Product
Contact Us
Tel:+86-010-58858988
Fax:+86-010-58858516
E-Mail: steven@fibridge.com
Address:A402, Power Creative Building, No.1, Shangdi East Rd, Haidian District, Beijing, 100085, PR CHINA
HD IP Video Surveillance

Daisy-chain Bandwidth Controllable IP Video Media Converter

Daisy-chain Bandwidth Controllable IP Video Media Converter

Brand name: Fibridge

Product introduction

introduction:  

Overview
F6-2124 series Node type Bandwidth controllable IP video optical transceiver is a Multi-functional, cost-effective new generation IP video optical transmission equipment which developed by Beijing Fibridge Co., Ltd. The device could support four 10/100Mbps Ethernet copper ports and two 1000Mbps fiber optic port, it can distribute the front-end IP video signals in series one by one as chain-type topology, the number of video signal transmission to the monitoring center through a single fiber. At the same time, the device supports a modular upgrade, if with the analog video access module, you can directly access analog video, provides a simple and low-cost data transmission solutions for the entire video surveillance system. The device uses the latest IP-based data processing chip, specifically optimized for IP video transmission characteristics, making IP video transmission with very low propagation delay, and at the same time, it also supports a variety of strategies VLAN and QoS, as well as the port data transfer bandwidth settings, making data transmission more cost-efficient.
The device supports SNMP/WEB/CONSOLE management, with a dedicated management software, the port speed, duplex mode, VLANs, QoS, port mirroring and rate limit can be configured, it can also realize remote monitoring and management.


Features
●Four 10/100Mbps Ethernet Ports and Two 1000Mbps uplink Fiber port
●Using specifically optimized data processing chip for IP video transmission to ensure high-speed low-latency packet forwarding, with average delay as low as 2ms
●The device supports a modular upgrade, if with the analog video access module, you can directly access analog video
●Support IEEE802.3, IEEE802.3u, IEEE802.3x protocols
●Inside MAC Address table which store up to 8000 MAC addresses
●Legal Maximum Packet size up to 1536 bytes
●Electrical Ethernet ports support 10Mbps, 100Mbps or 10/100Mbps, half/full duplex auto-negotiation
●Fiber optic port using single-mode single-strand SFP, LC type connector. Support Hot-swap, transfer distance up to 80 Km
●MDI/MDI-X auto-crossover on the Ethernet ports
●Support IEEE802.1q tag-based VLAN and port-based VLAN
●support up to 4000 VLAN entry configuration
●Support QoS, the QoS policies can be set based on port and IEEE802.1p
●Support IEEE802.1D Spanning Tree Protocol
●Support port mirroring, you can set a port to send or receive data to be mapped to other ports
●Support flow control, support for 802.3x flow control in full duplex mode, and backpressure flow control in half-duplex mode
●Port bandwidth can be set
●Support port-shutdown feature can individually set a port shut down or open
●It has a complete LED indicates the signal, it can indicate the port connection status, rate and full / half duplex mode
●Support SNMP/CONSOLE/WEB management
●The compact desktop design, can be easily placed on the desktop or rack


Management Function
●Support Console, WEB and SNMP management
●Configure the system information including the device name, device location information, IP address, start-up time and version information, etc.
●View the model of the device, and device parameter, working status of each port. Setting the Ethernet port status with management software.
●Real-time monitoring of optical link interfaces receive and transmit optical power, if overrun will alarm immediately
●Each port could be shutdown or open individually
●The bandwidth can be set
●Setting the broadcast protection rate at 0
99%
●Have the ability to set VLAN configuration based on port and IEE802.1Q. VLAN protocols
●Have the ability to set priority configuration based on IEEE802.1p
●Have the ability to set port mirror
●Possess the ability to show and search alarm messages information, which can follow the operation state of the conveniently
●Have the ability to summarize the data flow and show the operation state of each port in real time
●Support SNMP management. It is permitted to set Trap Destination, Community Name and the corresponding authorities
●Show the operation status and model of power supply completely
●With user grades for user manageme0nt and have the ability to validate user’s ID
●Have the ability to restart the equipment
●Reset to factory defaults via management software

Typical Application

 

Figure 1 using along with the IP cameras

Figure 2 using along with the analogue cameras

 

Technical Specification


Basic Type
●Optical port:
Rate: 1000Mbps
Duplex: Full duplex mode
Mode: single mode single fiber
Type: SFP, hot swap
Wavelength:1310nm/1550nm
Protocol: IEEE802.3z
Interface: LC
Transmission distance: at most 80Km
Support DDM
Port number: 2
●Ethernet Port:
Rate: 10/100Mbps with auto-negotiation
Duplex: Half/Full duplex mode with auto-negotiation
Connector: RJ45 Jack
Support automatic MDI/MDI-X crossover.
Port number: 4
●MAC address table capacity:                        
8000
●Propagation delay:                       
Less than 2ms
●Flow Control:
Half-duplex using backpressure
Full-duplex using IEEE802.3x
●VLAN setting:                       
Port-based VLAN
802.1Q tagged VLAN
QinQ
Private VLAN
GVRP dynamic VLAN configuration
●QoS setting
                      
Support port based QoS
Head of Line to prevent congestion mechanism
●Four transmit queues per port, mapping the 802.1p 8 priority
WRED/WFQ/SP/FIFO Queue scheduling algorithm
Best-Effort Service
Differentiated Service
Strict Priority
●Management:                       
SNMP/WEB/CONSOLE management
Support SNMP v1/v2 version
●Power supply:                        
Input:  AC 176-264V
50/60Hz
DC -36V~ -72V
Power consumption: Less than 8W
●LED:
Power, Link/Act, 10/100M, Duplex
●Environment
Working environment:
Temperature: 0℃ ~ 50℃;
Humidity: 0% ~ 95% (25℃);
Store and transportation environment:
Temperature: -40℃ ~ 85℃;
●Dimension
W×D×H: 252mm×135mm×36mm

Extended Module
●Video Interface
Video input: 1.0Vp-p, 75 ohm
Video input format: PAL/NTSC
Video coding format: H.264
Output resolution: 720p/D1/Half D1/CIF/QCIF
Frame rate:  PAL 1~25fps,
NTSC 1~30fps
Connector: BNC
Port number: 1/4
●Audio Interface
Coding format: G.711a/u, ADPCM
Connector: RCA
Port number: 1/4
●Alarm In/Out
1/2/4 channels bi-dir alarm input/output
Connector: Terminal block
Default output OPEN
●Output driving capacity: 3A/277VAC or 3A/30VDC
Data Interface
Protocol: RS-485
Connector: Terminal Block
●USB Interface
USB type: OTG
USB Ver: V2.0
Port number: 1
●SD Interface
SD type: SDHC
Capacity: 4GB(max.)

Order Information
Basic Type
F6-2124 Daisy-chain Bandwidth Controllable IP Video Media Converter, with up to 4-ch IP video input.

 

Extended Type
F6-2124-AV Daisy-chain Bandwidth Controllable IP Video Media Converter, with IP video and analogue video input.

Copyright © 2015 Beijing Fibridge Co,.Ltd. All Rights reserved
Tel:+86-010-58858988 Fax:+86-010-58858516 E-Mail:steven@fibridge.com